Manufactured by Klober, a leader in roof products, versatile Uni-Click dry verge units can be used with 260-350mm batten gauge on new build or existing roofs between 12.5° to 90° pitch.

Uni-Click is the easy-fit successor to the Uni-Dry system from Klober. Uses the same Eaves Ridge Pack and Ridge End Caps but units are not compatible with older Uni-Dry system and can't be used together.

Features & Benefits

• Quick fit system - no special tools, just click in to place and nail
• Resistance to Tile Uplift - roof tiles held firm, even in strong winds
• Zero maintenance - years of mortar free protection
• High quality - tough and UV stable plastic
• Mortar-Free - not affected by expansion/contraction and sever weather
• Mechanical Fixings - fit with reliable fixings in any conditions

Quick and Easy Fitting

The following provides a summary of the recommended steps for typical fitting of the Klober Uni-Click dry verge system.

• Prepare verge by removing any old mortar between the tiles and undercloak
• Fit Batten End Clip to end of every batten (extend tile battens 20mm beyond gable wall or bargeboard if required).
• Fit Eaves Closure to end of fascia board or brickwork
• Fit Eaves Closure to end of fascia board or brickwork
• Fit subsequent units (one per roof tile) until reach ridge. 1.Hooking under to engage with previous. 2. Click it over top of previous. 3. Slide up into position - inline with roof tile. 4. Nail to batten through batten end clip
• Insert Ridge Closure into last unit.
• The combs of the left and right Ridge Closure should interlock at the apex.
• Screw the Ridge End Cap to the ridge batten.