Manufactured to British Standard (EN1303: 2005), this is a cylinder that you can trust. Whatsmore, it comes with a 10 year guarantee!

Easy to fit - replace your existing euro cylinder with this in under 5 minutes!

Why have a High Security Euro Cylinder

Most uPVC and composite doors are fitted with a cylinder lock, which has a section cut out to provide space for a revolving cam. Turning the key revolves the cam, which engages the doors lock mechanism to lock and unlock. There are inherent weaknesses within the design but a high security cylinder can protect against them. Three good reasons why you should buy a high security euro profile cylinder:

• Protect your property - high security cylinders are a physical and visual deterrent
• Insurance compliance - failure to use an Insurance Approved cylinder could invalidate an insurance policy
• Peace of mind - trusting a high security lock means you can rest easy at night

Features & Benefits

• BSI Kitemark (KM532920) - approval you can trust
• BSEN 1303:2005 - highest European security
• PAS 024:2007 - British Standard for entrance doors when used with Yale security furniture
• Anti-Pick - spool pin protection
• Anti-Bump - resistance againt lock-bumping
• Anti-Drill - drill attack resistance
• Anti-Extraction - resists plug and cylinder pull
• 30,000 Key Differs - 6 pins with multiple positions
• Long Life - over 100,000 cycles
• Secured by Design - recommended by Association of Chief Police Officers

EXTRA KEYS - As standard, 3 keys are provided with single cylinders and 6 keys wih keyed-alike pairs. Additional keys can be requested above. Note that extra keys may be cut using Silca blanks.

Technical Information

Further technical information is available below.

Know the Threats

Thieves are always looking for new ways to compromise standard euro cylinder locks. Thankfully, manufacturers are constantly developing features within their locks that will combat threats such as Lock-Snapping and Lock-Bumping.

Visit our Upgrade My Lock website to find out more about euro cylinder threats, upgrading your euro cylinder and other measures to protect your home against theft.

What size do you need?

It's vital that you order the correct size cylinder for your door. To determine which size cylinder you require you must first remove the cylinder.

Removing existing cylinder

1. Put your key in the lock and open the door.
2. Remove the screw which is beneath the latch.
3. Turn the key while apply slight pressure to the opposite end of the cylinder. As you do so the cam will line up with the rest of the lock and you will be able to slide the cylinder out towards yourself. The key usually needs to be turned approximately 25 degrees clockwise or anti-clockwise.

You can now measure the original cylinder.

Measuring the existing cylinder

On the side of the cylinder, under the cam, you will see a Fixing Hole. The size you require is determined by the distance from each edge of the cylinder to the centre of the fixing hole.

1. Measure from the end of the cylinder to the centre of the Fixing Hole, to give the first measurement (a)
2. Measure from the centre of the Fixing Hole to the other end of the cylinder, to give the second measurement (b)

If measurement a = 35mm and measurement b = 45mm then the size required is referred to as 35/45 (80mm overall). Some double cylinders (key operated at both ends), like the Yale Anti-Bump and UAP+ Zero Lift Anti-Snap cylinders feature security on both ends. So, ordering a 35/45 cylinder is the same as ordering a 45/35 cylinder.