- Product Code: CLE-2042-1001
- Manufacturer Code: AG210
- Package Type: Parcel XL
- Shopping Category: Hardware > Building Materials > Roofing
Clear C-Section Edge Protector Trim for Multiwall Polycarbonate Sheets
(Choice of thickness and length)
Closes open ends of sheets and protects the edges!
Dual-purpose transparent uPVC plastic c-profile extrusion. Fits across twin-wall and triple-wall polycarbonate sheets to act as an end closure that protects breather tape and prevent ingress of water and insects, or can be used along the length as a protective edge trim.
Available for 10mm and 16mm thick multiwall polycarbonate sheets and in lengths of 2m (6ft 7in) and 3m (9ft 10in). A great product for protecting edges when over-sailing sheet directly across starter rafters.
NEW Stronger SNAPA Bar! The new PVC-u SNAPA bars are extruded with significantly thicker walls, which provides greater strength and rigidity over the low-grade aluminium of the old SNAPA bars.
Features & Benefits
- Discreet transparent appearance
- Designed for tighter hold on sheets
- Use with 10mm or 16mm polycarbonate
- Use as edge trim or end closure
- Strong and lightweight
- Simple push-fit design
A great ancillary product to the SNAPA Snap-Fix Glazing Bar system, which is a highly effective and low-cost lean-to roof capping solution for timber rafters. Common uses for SNAPA include: Carports, Greenhouses, Canopies, Covered Walkways and Pergolas.
Technical Information
Materials | PVC-u |
Size | For 10mm Sheets: 20mm (top lip), 14mm (front face), 12mm (bottom lip), 2m or 3m (length) For 16mm Sheets: 20mm (top lip), 14mm (front face), 12mm (bottom lip), 2m or 3m (length) |
Compatibility | 10mm or 16mm thick sheets |
Fitting the C-Section Trim
To fit, simply push the c-section onto the sheet and ensure that there is a little breathing space between the end of the sheet and the internal face of the c-section. It is often recommended to run a bead of neutral cure silicone on the underside of the top lip, to help seal and stick.